Show simple item record

dc.contributor.authorLeonard, L. E.
dc.date.accessioned2024-09-30T22:05:41Z
dc.date.available2024-09-30T22:05:41Z
dc.date.issued1977-08
dc.identifier.urihttp://hdl.handle.net/11122/15424
dc.descriptionUAG R-252; Final report consisting of three volumes: Vol. 1 - Cold start automotive emission in Fairbanks, Alaska (UAG R-239); Vol. 2 - A multiple restrike ignition system as a device to reduce cold start emissions : report; Vol. 3 - Carbon monoxide emission from moving vehicles in Fairbanks, Alaska (UAG R-252)en_US
dc.description.abstractThis report is the third and final volume in a series constituting the final report on a research project which has investigated carbon monoxide (CO) emissions from motor vehicle in Fairbanks, Alaska. This volume (Vol. 3) presents the findings of that part of the study dealing with vehicles operating in the moving mode. Two investigations were performed: 1. Driving cycles were developed which are representative of actual driving conditions in the urban area of Fairbanks. Development of two cycles was necessary to demonstrate the effect of traffic control strategies implemented during the summer of 1975. Therefore, the cycles presented here describe traffic conditions both before and after implementation of the new controls, with accompanying qualitative discussion of the effect on CO emissions. In an effort to retain consistency and ease comparison, the cycles developed here were modeled after the CVS-3 cycle used in the Federal Test Procedure. 2. CO emissions from in-use vehicles operating in the moving mode were measured in order to provide quantitative modal emission data for use in conjunction with the driving cycles. Quantitative emissions data for the steady-state mode of operation are presented; however, limitation in the response time of the CO analyzer used in testing precluded acquisition of reliable data for the transient (Acceleration and Deceleration) mode of operation.en_US
dc.description.sponsorshipPrepared for State of Alaska, Department of Highways, in cooperation with U. S. Department of Transportation, Federal Highway Administration.en_US
dc.description.tableofcontentsAbstract -- Acknowledgments -- I. Introduction -- II. Moving vehicle emission study - A. Background - B. Theory - 1. The modal method - a. Cold start - b. Warm idle - c. Moving vehicle - 2. Moving vehicle emissions - 3. The CVS system and the CVS driving cycle - C. Objectives - D. Test procedure - 1. Fairbanks driving cycle - 2. Moving vehicle emission factor - a. Steady-state - b. Transient - 3. Equipment - 4. Method - E. Problems in testing -- III. Moving vehicle study results - A. Fairbanks driving cycle - 1. Data reduction - 2. Data summary - 3. Discussion of results - a. Idle mode - b. Steady-state mode - c. Transient mode - d. Average speed - e. Fairbanks cycle vs. CVS cycles as used by FTP - B. Moving vehicle emission factor - 1. Steady-state response - 2. Transient response -- IV. Conclusions & recommendations – A. Conclusions – B. Recommendations -- V. Summary -- VI. References -- VII. Overall project summary.en_US
dc.language.isoen_USen_US
dc.publisherGeophysical Institute at the University of Alaska Fairbanksen_US
dc.subjectAiren_US
dc.subjectPollutionen_US
dc.subjectAlaskaen_US
dc.subjectFairbanksen_US
dc.subjectAutomobilesen_US
dc.subjectMotorsen_US
dc.subjectExhaust gasen_US
dc.titleCarbon monoxide emissions from moving vehicles in Fairbanks, Alaska : vol. 3 reporten_US
dc.typeReporten_US
refterms.dateFOA2024-09-30T22:05:42Z


Files in this item

Thumbnail
Name:
UAG-R 252.pdf
Size:
878.4Kb
Format:
PDF

This item appears in the following Collection(s)

  • GI Reports
    This series consists of Scientific reports, Technical reports and Final reports issued by the Geophysical Institute on all contracts and grants.

Show simple item record