Browsing College of Engineering and Mines (CEM) by Subject "Unsaturated Soils"
Now showing items 1-2 of 2
Development of a Computer Vision-Based Three-Dimensional Reconstruction Method for Volume-Change Measurement of Unsaturated Soils during Triaxial TestingProblems associated with unsaturated soils are ubiquitous in the U.S., where expansive and collapsible soils are some of the most widely distributed and costly geologic hazards. Solving these widespread geohazards requires a fundamental understanding of the constitutive behavior of unsaturated soils. In the past six decades, the suction-controlled triaxial test has been established as a standard approach to characterizing constitutive behavior for unsaturated soils. However, this type of test requires costly test equipment and time-consuming testing processes. To overcome these limitations, a photogrammetry-based method has been developed recently to measure the global and localized volume-changes of unsaturated soils during triaxial test. However, this method relies on software to detect coded targets, which often requires tedious manual correction of incorrectly coded target detection information. To address the limitation of the photogrammetry-based method, this study developed a photogrammetric computer vision-based approach for automatic target recognition and 3D reconstruction for volume-changes measurement of unsaturated soils in triaxial tests. Deep learning method was used to improve the accuracy and efficiency of coded target recognition. A photogrammetric computer vision method and ray tracing technique were then developed and validated to reconstruct the three-dimensional models of soil specimen.
Development of a Design Method for H2Ri Wicking Fabric in Pavement StructuresA new roadway drainage design concept is proposed to reduce the roadway water content and enhance the overall pavement performance by implementing H2Ri geotextile with lateral wicking ability. Compared with conventional drainage materials, this type of geotextile has high tensile strength and higher specific surface area, which enable to continuously transport water under unsaturated conditions. SEM (Scanning Electron Microscope) images indicated that the geotextile functions effectively for soils with particle size larger than 12 microns. A series of tests were performed to establish the relationships among different parameters, including resilient modulus test, large-scale direct shear test, salt concentration test and pressure plate test. Test results indicated that the soil-geotextile system can work effectively to reduce the water content within the pavement structure by 2%. By doing so, the corresponding resilient modulus can be increased by 3 times and the permanent deformation can be reduced to half of that value. Meanwhile, the interface frictional strength between geotextile and soil was not sensitive to water content change.